THE NOZZLE

Ok, so here is how the nozzle will look. I will post more later.

Now it's later and I have a minute. This is the nozzle that I am designing. The principle is basic. The water will enter into the tube tangentially into the nozzle chamber where it will swirl around until it gets to the sponge (not shown in picture above). The sponge will break up the flow and disorganized the flow. The sponge is juxtaposition to the straws, so the water will flow through the straws (shown as red in picture above). Once it exists the straws the water will be moving at the same speed. It will gather together in an open chamber before shooting through the brass exit nozzle. Once it leaves the brass exit nozzle it will be clear and beautiful. Then if the cutter mechanism is open the water will exit the top. If the water is being cut, the flow will continue through the side of the nozzle and back into the water system.

It's simple in theory! =) Now I just need to build it and make the water behave like I think it should behave.

A SPECIAL THANKS TO MARIO AND ZACHARY FOR HELPING ME WITH THE CRUCIAL SECTIONS OF THE DESIGN.